Home > Watercraft > Purists’ Bane

Purists’ Bane

August 5th, 2015 Leave a comment Go to comments

A simple boat built to test 3D-printed propellers and SBrick. Features a two independently controlled motors.

Datasheet:

Completion date: 04/08/2015
Power: electric (Power Functions)
Dimensions: length 57 studs / width 26 studs / height 16 studs
Weight: 0.673 kg
Suspension: none
Propulsion: 2 x PF L motor geared 8.33:1
Motors: 2 x PF L motor

 

This extremely simple boat was created to test 3D-printed propellers designed by Efferman and produced by Shapeways. I have also used this opportunity to employ an SBrick because its range was superior to that of LEGO PF IR receivers and it would not be affected by sunlight the way they are. I was aiming for good performance, so my goal was to limit the boat’s weight and drag as much as possible. To this end, it was kept afloat by three LEGO catamaran hulls which are profiled for minimal drag, and propelled by two PF L motors, both significantly geared up, each driving a single propeller.

Since the SBrick allows speed control, there was no need for rudder – instead, the speed of each motor was controlled independently, allowing to make turns at any angle, and also to turn on the spot. The propellers were 5 studs in diameter, 2 studs long, and rotated in opposite directions for better stability of the boat. The motors were connected to a single SBrick powered from a LEGO 8878 rechargeable battery which I’ve chosen for its low weight.

The boat was very similar to my first boat ever built, except it used just three hulls instead of four. This worked out, thanks to this boat being 200 grams lighter, but it was preceded by plenty of tests checking stability and load capacity. In fact, with the camera added I think the boat was very close to sinking and I have risked putting it on a lake with the camera only because the weather was very calm, no waves, no wind, and because the boat proved very stable. The propellers clearly outperformed almost all my LEGO boats except perhaps one which was using a single, very large propeller and two very powerful motors. I think the motors could be geared up even more, but I didn’t want to make the boat more complex and heavier. I think the propellers’ profile proved very effective, but their size could be larger.

Photos:

1.jpg dsc02387.jpg dsc02391.jpg dsc02396.jpg dsc02401.jpg dsc02403.jpg dsc02408.jpg dsc02421.jpg dsc02429.jpg

Video:

Media coverage:

3DPrint.com

Categories: Watercraft Tags: ,
  1. Sariel
    August 7th, 2015 at 21:51 | #1

    @MonoNick
    All my RC motors are in use at the moment, and I have geared up the PF L motors so much, I doubt RC motors would perform much better. These propellers are tiny and there is only so much performance you can get with them.

  2. MonoNick
    August 7th, 2015 at 21:12 | #2

    Hi Sariel,
    Are you going to try those propellers with RC motors ? %-)
    Nicolas

  3. Sariel
    August 6th, 2015 at 12:10 | #3

    @Alex
    I’m not reviewing the B-model, sorry.

  4. Alex
    August 6th, 2015 at 11:42 | #4

    By when can I hope to see the video

  5. Alex
    August 6th, 2015 at 10:47 | #5

    Hi Sariel I suggest it high time you make the B model of the Lego Mercedes benz 42043 set. The instructions have also come online.
    Hoping to see the video soon
    Alex

  1. No trackbacks yet.